Step By Step Directions for Milking the Prostate

!±8± Step By Step Directions for Milking the Prostate

The prostate is a gland of the male reproductive system. It is not found in women. Its primary function is the production of seminal fluid, and it also stimulates orgasm in males. The prostate gland can be affected by disease, including infectious inflammation or prostatitis, and prostate cancer, the second most deadly cancer among American males. Many people recommend milking the prostate regularly as a preventative treatment against prostate cancer and prostatitis.

Prostate milking is also referred to as prostate massage. It is a fairly simple procedure and you can do it yourself if you want to. Here are the steps to take in milking the prostate on your own:

1. Perform urination or a bowel movement in order to maximize the relaxation of the area.

2. Make sure that your fingernails are trimmed and have no jagged edges jutting out.

3. Clean your body and your hands thoroughly. Then put on a sterile latex glove on your hand. Dab a little water-based lubricant on your fingers.

4. Carefully insert your finger or fingers into your anus. Move them gradually upwards and to the back, along the area of the rectum towards the front of your body. Your fingers should be moving in roughly the direction of your navel.

5. You will feel the prostate gland, which is like a small, round bulb about the size of a large walnut. Gently massage it with a light waving motion along its sides, taking care not to press hard on the central area, where the sensitive nerves are located. Avoid touching the prostate gland with your fingernails.

6. You may experience a disconcerting sensation that makes you feel like going to the bathroom although you do not have to. Try not to let it affect you, and continue with the procedure.

7. After a few minutes, the prostate gland may be stimulated enough for ejaculation to occur. You are also likely to experience sexual pleasure or orgasm. However, the procedure does not always successfully bring about ejaculation.

Prostate milking when used as a preventative treatment may carry a few risks. It is a technique that is not recommended for men who have a disease of the prostate or acute prostatitis, an acute inflammation of the glandular tissue. The problem in such cases is that the act of milking the prostate may cause the infection to spread to other areas of the body.

Step By Step Directions for Milking the Prostate

Buy Infant Neocate Formula Horizon Fitness R3 Recumbent Exercise Bike Order Now

Videographers - Solid Microphone Techniques

!±8± Videographers - Solid Microphone Techniques

Always remember that when shooting a production, terrible sound is the most unforgivable offense there is. Shooting a scene that is a bit too dark or a scene that may be too blurry because of all the action is usually forgivable, especially if the content is good, but shoot a scene where the audio is terrible and your audience can't understand, and they will walk out on you.

From home movies to million dollar productions, sound is a key component in allowing your production to be as professional as possible. Poor quality audio is a dead giveaway of an amateur production. Even George Lucas can be quoted as saying "sound is fifty percent of the movie-going experience." In order for you to understand how to get the best possible audio for your production, we have assembled a few tips and techniques for you to look at. Keep these in mind on your next production shoot.

Built-in Camera Mics

The general rule is to never use the built-in camera microphone unless you are using it as a second channel to only pick up background ambient sound. However if you are forced to use it as a main source of audio, then remember the following:

Shoot Inside Point the Camera Directly at the Subject Have the Subject Speak Clearly Make Sure There is Minimal Background Noise

The main downfall of using the built-in mic is that if you have to shoot outside, you are going to have an extremely difficult time not picking up other background sounds.

Handheld Microphones

These are the most popular microphones for location interviews. Both sporting events and news and information programs will use a traditional handheld stick mic for field interviews. These microphones come in both a wired and wireless set-up. Although a wireless microphone is always more convenient for the person using it, the sound engineer must always be aware of the possibility of RF (radio frequency) interference. The proper positioning of the microphone from the face is important. Too close will result in popping P's and possible distortion and a mic that is too far from the face will result in too much ambient noise getting into the recording. Spend time doing audio checks to learn the best microphone placement.

Lavalier Microphones

Lavalier microphones are commonly used in studio news and information format programs. A big benefit with these mics is that they are very small and unobtrusive to the viewer while still giving great sound quality in a controlled environment. When working with a lav mic, experiment adjusting the mic placement on the subject to allow for optimum sound quality.

Lavalier microphones are also available in both wired and wireless setups.

Boom Mics

This is in fact the "go-to" microphone for most television shows, major movie productions and documentaries. This is also the more expensive way of recording sound since it involves an additional person - a Boom Operator. The trade-off is worth it however since there is no visible evidence of a microphone in the shot. An experienced Boom Operator who can work well with camera operators is an asset to any production.

Noise Reduction

Always arm your microphones - no matter what setup you use, with windscreens. Windscreens not only protect you from raging wind sound, but they also help to cancel out other outside background noises that may be going on around the production. You can purchase windscreens for a reasonable amount, and they come in low-tech versions (hand held or lav mics) and high-tech versions (boom mics). The heavy-duty outdoor windscreen is called a zeppelin.

Shock Mounts

These are beneficial to have on bigger shoots when using a boom mic setup. The shock mount helps isolate the microphone from the boom pole and will eliminate sounds from your hands and fingers while you hold the boom. Most boom mics come with this, but if not there are plenty of generic shock mounts you can purchase for a reasonable price.

All of these types of mic setups - if used the proper way, will take your production to the next level, even if you are using low-end equipment. Remember - and I can't state this enough, good quality audio is more than half of a good production.

Videographers - Solid Microphone Techniques

Power Washers Free Shipping Purchasing Oxo Can Opener Buy Silk Epil